Home » DIY

Category Archives: DIY

DIY art to make your home special

  1. Vintage-Globe Light

To make your own particular globe light, you’ll require a 12-inch-measurement cardboard globe, in addition to a pendant light rope unit .To begin with, expel your globe from its base, if necessary. With a utility blade, deliberately make a 3½-inch-breadth opening at the base of your globe, using its scope lines as a guide

At that point, holding the light string’s attachment at the highest point of the globe will help you get a better understanding of how to proceed, then follow around it with a pencil, and cut out the subsequent circle. Utilizing a drill fitted with a ⅛ – inch bit, penetrate little openings around the blueprint of every landmass, leaving a quarter inch between gaps. Embed the attachment at the best, after the pack’s guidelines; at that point fasten a 15-watt CFL knob from the base, and hang.


  1. Papier-Mâché Bowls

Stage 1: Tightly cover the outside of your bowl with saran wrap, anchoring it within with painter’s tape, and flip around. In another bowl, blend a balance of glue and water. Dunk the paper into the blend, uniformly covering each piece; at that point lay the strips on the plastic-wrapped bowl so they cover, until the point when the bowl’s outside is totally secured. Let dry for three hours.

Stage 2: Flip the bowl right side up and trim away any overabundance paper along the edge with scissors. At that point, release and separate your paper bowl from the plastic-wrapped bowl.

Stage 3: Paint the inside of your paper bowl with white acrylic paint and let it dry for 60 minutes; after which, go ahead and paint the outside and let it dry for 60 minutes.

Stage 4: Cover the outside of your paper bowl with wax paper, anchoring it to the bowl’s external edge with painter’s tape.

Stage 5: Apply Liberon Wax to the inside of the bowl with a delicate fabric. Allow the wax to set for 60 minutes, after which, you must delicately buff to a sparkle with a clean delicate material. In the end, take off the tape and wax paper, and show a couple of beautiful treasure that you own using this.


  1. Designer Paper Clock

Designer paper is all you have to update a wall clock. Utilize a screwdriver to pop off the clock’s back and battery, and after that lift out the face. Delicately evacuate the hands, nut, and washer with forceps. Put aside all parts, taking note of how they have to be reassembled. Follow the shape of the clock and cut out the circle. Focus the paper on the face, designer side looking out, and secure with twofold sided tape. Utilize T-pin to jab an opening through the paper for the clock hands; reassemble all parts and hang.